VT-Kit-1 Professional Test Kit
- Remove bottom cup by screwing it counter clockwise.
- Snap fit aerosol can into the cusp with the nozzle up.
- Screw aerosol cup with can in place clockwise into base
unit, until aerosol is slightly released
- Unscrew the cup counter clockwise approximately half a
turn to eliminate the pressure on nozzle.
- Insert yoke end of dispenser into end of Versa-Pole.
For additional reach add the VP-4X Adapter to top of VP-16 and insert
dispenser into the adapter
- Placing the open end of chamber over the detector, ensure
a tight seal to the ceiling Press upwards on the pole to engage. Only
slight upwards pressure is required to release the appropriate amount of
gas to activate the alarm’s sensor.
- Remove chamber from alarm to clear the sensing chamber.