Remove bottom cup by screwing it counter clockwise.
Snap fit aerosol can into the cusp with the nozzle up.
Screw aerosol cup with can in place clockwise into base
unit, until aerosol is slightly released
Unscrew the cup counter clockwise approximately half a
turn to eliminate the pressure on nozzle.
Insert yoke end of dispenser into end of Versa-Pole.
Placing the open end of chamber over the detector, ensure
a tight seal to the ceiling Press upwards on the pole to engage. Only
slight upwards pressure is required to release the appropriate amount of
gas to activate the alarm’s sensor.
Remove chamber from alarm to clear the sensing chamber.
